 |  |  |  |  |  |  |  |  |
 |
|  |
11-29-2010, 10:21 PM
| |||
| |||
| Barrel Help Last year i bought a m4 barrel for my 98c. this year i decided to finish of the marker with a sight rail and a magazine. since my barrel doesn't have a rail for a forward grip i was wondering if i could install a rail onto the barrel. i will put on a picture but its not the greatest. I'm new to the site and would be grateful for the help.
__________________  TeNSioN  |
|
11-30-2010, 11:57 AM
| ||||
| ||||
| Re: Barrel Help with a little bit of ingenuity anything can be done but in most cases that requires some permanent modding. Did your barrel come with a delta ring? in that case a grip should screw right on there. Otherwise you can use JB weld or something to "glue" it on there. Or se how it is attached on the Alpha Black. I would recommend going through the other threads and looking at what has been done, I bet there is at least one other that has had the same problem as you. when i made my foregrip i made it slide about 1cm on top of the marker and then i put a ring on the barrel so that the grip is pushed back when the barrel is screwed in adn is thus firmly held in place. But i'm guessing it would not work for a m4-type look.  |
|
11-30-2010, 09:14 PM
| ||||
| ||||
| Re: Barrel Help devlin, r u russian
__________________ IF YOUR UNDER 18 AND PAY FOR YOUR OWN GEAR PUT THIS IN YOUR SIGNATURE  |
 |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 11:29 AM.
